Grass Valley Kaleido-Modular-X v.7.70 - Manual (Page 36)

32
Setting Up Your Kaleido-Modular-X System
Networking Setup
9 Under General, type the name you wish to use for your system.
If there are more than one multiviewer in the same network environment, it is
important to assign each a unique system name, so that you can tell them apart (for
example, when using a remote control panel such as the Kaleido-RCP2 or RCP-200).
Only lower-ASCII characters are allowed in the system name. Braces and tilde are not
allowed.
10 Click Save.
The new settings are saved locally, and XAdmin reminds you to click Apply Setting
before closing your session.
11 Click OK.
The Apply settings button becomes available.
Note: Under Ethernet, you may review the IP addresses, network mask,
gateway settings, and the detected connection speeds and duplex modes.
Should you wish to make any further changes to the network settings, you
may find it more convenient to use XAdmin’s System configuration page,
from now on.