Grass Valley Kaleido-Modular-X v.7.70 - Manual (Page 38)

34
Setting Up Your Kaleido-Modular-X System
Networking Setup
2 On the Kaleido-RCP2 unit, press the ENTER button and hold it until the ESC button
lights up.
The following message appears on the LCD display:
Configuration
ROOM SELECTION
3 Press ENTER again to obtain the room list from the multiviewers that are currently
available on the network.
The message ROOM Select followed by the name of the first room available appears on
the LCD display.
4 Press the 2 key (to move up in the list) or the 8 key (to move down the list) until Room1
is displayed.
5 Press ENTER, and then press ESC to exit the configuration menu.
6 Press the LOGIN button.
The following message appears on the LCD display:
LOGIN Position
Admin
7 Press ENTER to log on to your system as “Admin”.
A message prompting you for a password appears on the LCD display.
8 Press ENTER again (by default, there is no password).
The message “Access granted” will appear on the LCD display if the login is successful. If
a mouse is connected to the Kaleido-RCP2, then you should be able to see and move
the mouse pointer on the monitor wall.
9 Press any of the LAYOUT PRESETS buttons to load a predefined layout on the monitor
wall.
If your system was configured prior to shipment, then a layout will appear on all
displays. Otherwise, a gray screen will appear with the following message in the
middle:
“No layout has been assigned to this room. Please load a layout.”
Configuring an Audio Bridge Terminal
The optional Audio Bridge Terminal (ABT) is an external audio multiplexer/serializer for the
Kaleido-Modular-X. The Kaleido-Modular-X supports audio channel inputs from the ABT-64
or ABT-128 series of Audio Bridge Terminal panels through the KMX-3901-IN input cards
ABT/MADI inputs. The ABT-64 supports 64 channels and the ABT-128 supports
128 channels.
There is not enough space on the Kaleido-Modular-X rear panels to also include discrete
audio connectors. An ABT provides connector space for multiple audio signal inputs, and
multiplexes all the audio signals into combined serial feeds on coaxial cables that connect
to the KMX-3901-IN input cards.
Note: To access other layouts, press the LOAD button. To assign a layout to
a preset button, press and hold the button for more than six seconds while
the desired layout is showing on the monitor wall.