Grass Valley Kaleido-Modular-X v.7.70 - Manual (Page 26)

22
Setting Up Your Kaleido-Modular-X System
Networking Setup
output card’s IP address doubles as the system IP address). Kaleido-Modular-X output cards
are shipped with the following default settings:
Densité 3 and Densité 3+ FR1 housing frames are shipped with their CPU-ETH2 controller
configured with the following default settings:
£
Once the networking parameters are correctly configured on your Kaleido-Modular-X
output cards, it will not be necessary to switch off the housing frame’s power when
installing or removing cards.
To set the system name and IP addresses for your Kaleido-Modular-X multiviewer
1 If any frame housing your Kaleido-Modular-X input and output cards was not already in
operation, configure its Densité CPU-ETH2 controller’s networking parameters. See
Setting a Densité CPU-ETH2 Controller’s IP Address on page 23.
2 For every frame housing Kaleido-Modular-X input or output cards, verify that the
Densité CPU-ETH2 controller’s automatic restore feature is enabled (see Enabling the
CPU-ETH2 Automatic Restore Feature , on page 24).
3 Configure your output cards’ networking parameters:
• If you are setting up a quad-head Kaleido-Modular-X, replace the system
IP address, network mask, default gateway, and both output cards’ IP addresses as
appropriate. See
Configuring the Network Settings for a Quad-Head System on
page 27.
The system IP address will be your system’s virtual IP address. This is the address
you will use to access your system from XEdit and XAdmin, for example.
KMX-3901-OUT default IP settings
System IP address 192.168.3.31
Network mask 255.255.255.0
Gateway 0.0.0.0
Output A IP address 192.168.3.31
Output B IP address 0.0.0.0
Densité CPU-ETH2 controller default IP settings
IP address 1 192.168.3.1
Network mask 255.255.255.0
Gateway 0.0.0.0
IP address 2 0.0.0.0
Network mask 0.0.0.0
Gateway 0.0.0.0
Note: For the card hot swap feature to function properly, the CPU-ETH2
automatic restore feature must be activated on all frames housing
Kaleido-Modular-X cards (i.e., both input and output cards).