Grass Valley Kaleido-Modular-X v.7.70 - Manual (Page 31)

27
Kaleido-Modular-X
Quick Start Guide
After a moment, the card restarts. The startup sequence takes approximately four
minutes, during which time the Status LED is first red and then blinking orange. Once
the startup has completed, the Status LED should be red (steady) because the card is
not connected to the network yet.
16 Connect the output card’s ETH port to your Ethernet switch.
17 Check the card’s Status LED again, and make sure that it does not indicate an error
condition.
Should the Status LED indicate an error condition, refer to your Kaleido-Modular-X
Hardware Description & Installation Manual to find out what the other LEDs might be
indicating.
18 Verify that the new IP address is effective, by referring to Verifying an Output Card’s IP
Address and Application Version , on page 46.
Configuring the Network Settings for a Quad-Head System
To configure the network settings for a Kaleido-Modular-X with two output cards
1 Press the Select button on the front edge of one of your system’s output cards.
• If you changed a parameter from the card’s control menu, but have not
applied your change (you did not press the SEL button on the local control
panel), once the 30-second timeout has occurred, the parameters will be
confirmed as if you had pressed the SEL button.
Green Normal
Blinking orange Booting (or the card is selected for local control)
Red Firmware initialization in progress / no Ethernet / SD card error
Blinking red Fan failure / no rear / duplicate IP address
Notes (continued)