Grass Valley Kaleido-Modular-X v.7.70 - Manual (Page 34)

30
Setting Up Your Kaleido-Modular-X System
Networking Setup
After a moment, the card restarts. The startup sequence takes approximately four
minutes, during which time the Status LED is first red and then blinking orange. Once
the startup has completed, the Status LED should be red (steady) because the card is
not connected to the network yet.
19 Press the Select button on the front edge of the other output card, and repeat from
step 2 , to configure the second output card with the same network settings.
20 Connect both output cards’ ETH ports to your Ethernet switch.
21 The system momentarily reports a duplicate IP address on the monitor wall, after which
Output B restarts. Once the startup has completed, check both cards’ Status LEDs
again, and make sure that they do not indicate an error condition.
Should the Status LED indicate an error condition, refer to your Kaleido-Modular-X
Hardware Description & Installation Manual to find out what the other LEDs might be
indicating.
22 Verify that both cards’ and the system’s new IP addresses are effective, by referring to
Verifying the Multiviewer’s IP Addresses and Application Version , on page 45.
Setting the System Name
Once you have configured the output cards from the local control panel, use XAdmin to
complete your system’s network setup.
To set your Kaleido-Modular-X system name
1 Configure your client PC or laptop with an IP address in the same range as the
multiviewer’s current IP addresses if needed (see Configuring a Client PC , on page 36).
2 Open a Web browser window and enter the multiviewer’s system IP address in the
address bar (see Finding the System IP Address , on page 45, if needed).
3 The Kaleido-X home page appears.
Green Normal
Blinking orange Booting (or the card is selected for local control)
Red Firmware initialization in progress / no Ethernet / SD card error
Blinking red Fan failure / no rear / duplicate IP address