Grass Valley Kaleido-Modular-X v.7.70 - Manual (Page 33)

29
Kaleido-Modular-X
Quick Start Guide
FRAME IP ADDRESS EDIT appears on the control panel’s display.
5 Press the [–] button.
NETMASK EDIT appears on the control panel’s display.
6 Repeat step 3 and step 4 to configure the netmask.
7 Once you have set the network mask and navigated back to the previous menu level,
press the [–] button again.
DEFAULT GW EDIT appears on the control panel’s display.
8 Repeat step 3 and step 4 to configure the gateway.
9 Once you have configured the gateway and navigated back to the previous menu level,
press the [–] button again.
LINK MODE EDIT appears on the control panel’s display.
10 Press the SEL button.
11 The current link mode (“Auto-negotiate”) appears on the LCD display.
12 If your network's mode of operation requires you to change the link mode, press the [+]
and [–] buttons to navigate to the suitable option (100 Mbps half-duplex, or 100Mbps
full-duplex), and then press SEL to apply the value shown on the display.
The selected link mode is applied.
13 Press ESC to return to the previous level in the local control menu.
LINK MODE EDIT appears again on the LCD display.
14 Press the [–] button.
OUTPUT A IP EDIT appears on the control panel’s display.
15 Repeat step 3 and step 4 to configure the IP address for Output A.
16 Once you have set the IP address for Output A, and navigated back to the previous
menu level, press the [–] button again.
OUTPUT B IP EDIT appears on the control panel’s display.
17 Repeat step 3 and step 4 to configure the IP address for Output B.
18 Once you have set the IP address for Output B, press the Select button on the front edge
of the output card to exit the control menu.
Note: On all Kaleido multiviewers, the network adapters are set to auto-
negotiate. By default, the connection speed and duplex mode will be set
automatically based on the corresponding port settings on the switch.
Notes
• If you do not press any button on the Densité frame local control panel, the
Densité controller will revert to its normal standby mode, and the selected
card's Status LED will revert to its normal operating mode, after 30
seconds.
• If you changed a parameter from the card’s control menu, but have not
applied your change (you did not press the SEL button on the local control
panel), once the 30-second timeout has occurred, the parameters will be
confirmed as if you had pressed the SEL button.