Grass Valley Kaleido-Modular-X v.7.70 - Manual (Page 28)

24
Setting Up Your Kaleido-Modular-X System
Networking Setup
IP ADDRESS appears on the control panel’s display.
6 Press the [–] button.
NETWORK MASK appears on the control panel’s display.
7 Repeat step 4 and step 5 to configure the netmask.
8 Once you have set the network mask, press the [–] button again.
GATEWAY appears on the control panel’s display.
9 Repeat step 4 and step 5 to configure the gateway.
10 Once you have set the gateway, press the CONTROLLER button to exit the controller’s
menu.
The Densité controller restarts.
11 Connect the controller card’s ETHERNET 1 port to your Ethernet switch.
Enabling the CPU-ETH2 Automatic Restore Feature
To enable the CPU-ETH2 automatic restore feature
1 On the Densité frame’s local control panel, press the CONTROLLER button.
2 Press the [–] button repeatedly until RESTORE POINTS appears on the display, and then
press the SEL button.
3 Press the [–] button repeatedly until DEFAULT ACTION appears on the display, and then
press the SEL button.
• If the control panel’s display shows UPDATE SETTINGS, then the automatic restore
feature is already enabled.
Note: Pressing ESC when the input focus is in the first position returns to
the previous menu level. Pressing SEL when the input focus is in the last
position saves the changes and returns to the previous menu level.
Notes
• The Kaleido-Modular-X does not support the controller card’s second
Ethernet port (ETHERNET 2).
• To avoid IP-address conflicts, you should wait until you have configured
the appropriate network settings for your KMX-3901 output cards before
connecting the output cards’ ETH ports to the network.
IMPORTANT
Make sure the controller’s internal clock is set to the correct date and
time.
The clock settings will persist for 10 days after a power loss. Should you later
need to change the time on a CPU-ETH2 controller, then you will have to
restart any multiviewer system housed in the same frame. Refer to the
Densité CPU-ETH2 Enhanced Ethernet Controller Card Guide to Installation
and Operation, for more information.