Grass Valley Kaleido-Modular-X v.7.70 - Manual (Page 14)

10
Setting Up Your Kaleido-Modular-X System
Physical Setup
Example: 4K UHD prescaler’s FlexBridge outputs A1 and B1, connected to
3G/HD SDI inputs 5 and 6, at the rear of a KMX-3901-IN-16-D input card
10 Connect the Kaleido-RCP2 and the Audio Bridge Terminal (if available) to a dedicated
100Base-T Ethernet switch. You can also connect a mouse and a keyboard to your
Kaleido-RCP2.
Kaleido-Modular-X output cards automatically detects the resolution of any connected
display. If the required information is not available, then a fall-back resolution of
1920 × 1080 @ 60 Hz (HDTV) is used.
Notes
• The Kaleido-RCP2, and Audio Bridge Terminal (ABT) are optional devices,
and may not have been shipped with your Kaleido-Modular-X system. For
information on these and other Kaleido-Modular-X options, please contact
your Grass Valley sales representative.
• You may need to upgrade your Audio Bridge Terminal and Kaleido-RCP2
devices (if available) to the latest firmware. The update files can be found
on the DVD that shipped with your multiviewer, and on Grass Valley’s
support portal. Please refer to the Kaleido-RCP2 Guide to Installation and
Operation, and to the Audio Bridge Terminal Guide to Installation and
Operation (available on the DVD, and from the portal) for instructions on
how to determine the firmware level, and how to perform the upgrade for
these devices.
• The Kaleido-Modular-X supports one ABT device. With a 3RU model, you
can achieve redundancy by connecting the ABT to more than one input
card, in which case the Kaleido-Modular-X system uses the signal from the
input card that is the farthest from the output cards (i.e., Input D, if you
have 4 input cards, Input C if you have 3 input cards, Input B if you have 2
input cards).