Grass Valley Intuition XG v.5.0 User Manual
Page 79
5-16
Intuition XG Configuration Guide
Dashboard - Intuition XG’s Local Configuration Software
O
UTPUT
•
R
ESOLUTION
: Allows you to set the resolution format that is used for
processing within the Vertigo device. You can set the output Resolution either
in this field or in the O
UTPUTS
R
ESOLUTION
field on the A
DVANCED
>R
ESOLUTION
PAGE
(
•
C
HANNEL
: Specifies the output channel used by the Vertigo device. The
available output channels are determined by the installed hardware. You can
set the Output Channel either in this field or in the O
UTPUTS
C
HANNELS
field on
the H
ARDWARE
S
ETTINGS
>V
IDEO
PAGE
).
M
ODE
The Mode setting specifies the processing mode of the Vertigo device.
•
U
P
S
TREAM
: When UpStream mode is enabled, the device is configured as
follows:
1.
There is no video input.
2.
The device outputs both a fill and key signal.
3.
The Watch Dog is enabled.
4.
The Watch Dog key signal is transparent.
•
D
OWN
S
TREAM
: When in Downstream mode is enabled, the device is
configured as follows:
1.
The device processes video input and the input channel
matches the output channel.
2.
The device outputs only a fill signal.
3.
The Watch Dog is enabled.
4.
The Watch Dog key signal is transparent.
•
A
DVANCED
: When this read-only field is enabled, it indicates that the device
has been configured through the Advanced setting mode so that its settings
do not match the Upstream of Downstream settings.
G
ENLOCK
This setting controls the sync of the Vertigo device. It is a simplified view of the
A
DVANCE
>H
ARDWARE
SETTINGS
>G
ENLOCK
PAGE
.
•
S
OURCE
: Specifies the source of the Genlock signal. Choose from the
following settings: I
NTERNAL
, B
LACKBURST
, V
IDEO
I
N
A, or V
IDEO
I
N
B (assuming
the hardware contains inputs).
•
R
ESOLUTION
: Specifies the resolution of the Genlock signal. The Resolution
can also be set on the H
ARDWARE
S
ETTINGS
>G
EN
L
OCK
page (
•
S
TATUS
: Reports the status of the Genlock signal (i.e. the Intuition XG has
locked onto the signal). The Status can also be set on the H
ARDWARE
S
ETTINGS
>G
EN
L
OCK
page (
).