Grass Valley Intuition XG v.5.0 - Manual (Page 58)

Intuition XG Configuration Guide 4-9
Intuition XG Portal - Intuition XG’s Remote Configuration Tool
Configuring Intuition XG’s network settings
The Intuition XG Portal allows you to conveniently configure the Intuition XG device’s
network settings from a remote workstation. The Portal’s N
ETWORK S ETUP page allows you
to change the following settings: IP A DDRESS , S UBNET M ASK , and D EFAULT G ATEWAY .
We recommend that a static IP address be assigned to the Intuition XG device when it is
originally installed and configured. In some cases, however, the Intuition XG device may
have been originally configured using DHCP. If so, the Network Setup page will display the
following warning:
This Intuition XG is currently configured to obtain IP addresses
automatically using DHCP. Using DHCP is not recommended.
Since using DHCP is not recommended, we ask that you enter a new IP address on the
Network Setup page, which will immediately assign a static IP Address to the Intuition XG
device.
N OTE
Changing the IP address will require that you reconfigure the Device settings for this
Intuition XG device on the central Xmedia Server.
To change the Intuition XG device’s network settings:
1.
Log into the Intuition XG’s Portal (see page 4-2 ).
2. Select the S ETUP >N ETWORK S ETUP command.
The Portal’s N ETWORK S ETUP page appears (figure 4-8 ).
Figure 4-8. The Intuition XG Portal’s Network Setup page
3. To change the IP A DDRESS , S UBNET M ASK , and/or D EFAULT G ATEWAY values, type the
new value in the corresponding text box.