Grass Valley EDIUS Pro v.7.0 - Manual (Page 67)

59
Basic Editing Operations
EDIUS - User Guide
Slip Trim
0
You can change the part of the clip to be used without changing the length or position of the clip. The length or position
of the adjacent clips remain unchanged.
Rolling Trim
0
Shift the start and end points of the previous and subsequent clips without changing the length of specific clips.
Adjust the range to be used while checking the video displayed on the preview window.
3
•
You cannot perform trimming if the adjacent clip has no margin. When trimming clips with margins, trimming can
be performed by the length of the margin of the clip.
Trimming on the Timeline
Depending on the trimming type, the selected point or the shape of mouse cursor differ. Perform editing operations
according to the following chart.
1 Click and select the cut point of the clip to be trimmed.
The cut point for each trimming type can be selected as follows:
3
•
Ripple trimming is also possible when the ripple mode is off.
In point trim Click the In point of the clip.
Out point trim Click the Out point of the clip.
Ripple trim Click [Shift] + In point or Out point.
Slide trim Click [Ctrl] + [Shift] + In point or Out point.
Split trim Click [Alt] + In point or Out point.
Slip trim Click [Ctrl] + [Alt] + center of the clip.
Rolling trim Click [Ctrl] + [Shift] + center of the clip.