Alinco DJ-X2000 - Manual (Page 56)

55
3.1.27 Transweeper™
This function is used to detect a wireless microphone or any other bug using
radio and locate the place where it is installed. If you previously assign any
frequency expected for bugging purposes to the memory channel or auto
memory channel, the DJ-X2000 will scan for that frequency. The settings for
bank link and channel skipping will become valid.
1
Turn ON the transweeper.
Press the key, and then press
the key while is shown
on the display.
The transweeper will start.
The scanning varies depending on the basic mode in
use.
VFO mode The scanning is performed from the currently received
frequency toward higher frequencies. The scanning
direction is changed using the dial or
UP/DOWN key.
MR mode Only the specified bank is scanned. The settings for
bank link and channel skipping become valid. Pressing
the
key starts the scanning.
PMS mode The scanning is performed only within the programmed
scanning range that you have specified.
2
Check for bugging.
In this state, control the sound volume and the orientation
of the DJ-X2000. If the existence of any bug is detected,
the display changes as shown here.
3
Search for the location of the bug while slowly bringing the DJ-X2000
closer to that bug.
You can find the distance to the location of the bug according to the changes on
the display.
• As the DJ-X2000 comes closer to the bug.
SCN
A~B S
ENT
TF
F
MODE
AUTO MW
X2
MIC
SCRT PRIO
REC
CTCSS
F TUN E
A-B S
M NAM E
TF
SKIP
STEP
ATT
SET
POW ER
RX/S T
PMS
VFO
MR M W
A B
SET
KL
3
6
9
8
0
5
2 1
4
CLR
ENT
MIC
SCN
RF C
HELP
7
MON
I
F
SRC
H
LAM
P
SQL VOL
D OW
N UP
T
N N O F O U D
F
A
(
1 1 5 4 .
) ＿
, ,
A
(
1 1 5 4 .
) ＿
, ,