Alinco DJ-X2000 - Manual (Page 19)

18
Precautions in recharging
1. Ensure that the transceiver is OFF when recharging the battery pack. The use
of the transceiver during recharging can cause the transceiver to malfunction.
2. The battery charger is designed to be used at an ambient temperature
between 10°C and 40°C (50°F and 104°F). Avoid recharging the battery pack
at any temperature outside this range.
3. Do not repeatedly recharge a fully recharged battery pack. This can cause
the performance of the battery pack to deteriorate. The battery pack can be
recharged up to 300 times when it is used normally. If the life of the
completely recharged battery pack becomes markedly shorter, the battery
pack is considered to have been exhausted. Please purchase a new battery
pack.
4. Do not insert the battery pack in a reverse direction.
5. When the battery pack has been recharged completely, with the lamp blinking
green, remove the battery pack from the battery charger.
6. If the battery charger is not used for a long period of time, disconnect the AC
power cord from the wall socket, and remove the battery pack from the battery
charger.
7. If you recharge a battery pack of which voltage has abnormally dropped due
to discharge, the lamp starts blinking red and a preliminary recharge initiates
immediately after you have started recharging the battery pack.
Subsequently, the lamp will be illuminated red, indicating that the quick
recharge has started.
8. If any irregular battery pack is set in place, the lamp will blink alternately in red
and green.
1.5.4 Battery low alarm
When batteries get low, the icon appears on the
display to the sound of a repeated siren-like alarm.
Change the batteries as soon as possible.
However, the alarm is not emitted if the beep function is
turned OFF.
Note: If you use the DJ-X2000 with the exhausted batteries being mounted in a
state of unable to turn on the power switch. It may become unable to accept
any external power. If the DJ-X2000 will not start even when you press the
power switch, press the hardware reset key or detach the battery case more
than 10 seconds before connecting any external power.