13 resetting the receiver – Alinco DJ-X2000 User Manual

Page 42

Enter a message.

Select each character by turning the dial, and then establish it by pressing the

DOWN

key. Pressing the

key allows you to cancel the established character.

Up to 36 characters may be entered (the initial setting is

ALINCO INTELLIGENT

RECEIVER

Finish the setting.

After you have finished entering the characters, press the

key.

The display will return to the CONFIG menu. Point the arrow at

END

and then

press the

key (Alternatively, you may press the

key, and then press the

key while

is shown on the display.

Note:

• If you exit the CONFIG menu by pressing the

key, the changed

setting is canceled.

• If you turn the dial while holding down the

key, you can move 11

characters ahead.

3.1.13 Resetting the receiver

This command resets the DJ-X2000. Be careful as all settings you made up until
now may be cleared from memory, depending on your selection.

While holding down the

key,

turn ON the power. When the DJ-
X2000 starts up, the USER RESET
menu will appear on the display.

Move the arrow to the reset command you want, using
the dial or the

UP/DOWN

key. Then, press the

key.

Reset commands are described here following.

CANCEL

Cancels the reset command entirely.

SYSTEM

Initializes user-set functions, but it does not clear memory
channels. (Choose this normally.)

ALL

Clears all functions and memories.

ENT

POW

RX/S

PMS

MR M

SET

MONI

SQL VOL

CLN

S P

CLR

SKIP

ENT

CANCE L

S Y S T EM

USER RESET

CAUTION:

It takes time to complete the resetting. Do not turn ON the power

during the reset.