Alinco DJ-X2000 - Manual (Page 35)

34
Note: • The attenuation level slightly varies depending on the frequency.
• In the PMS or MR mode, setting DIRECT WR to ON enables selection of a
frequency step and modulation mode and adjustment of the attenuator and
CTCSS decoders. For further details, see “3.1.30 Directly changing the
settings” (page 60).
3.1.4 Battery Save
When ON, the battery-save feature automatically saves battery power whenever
keys are not used or a signal is not picked up for a certain amount of time.
1
Call up the BATT SAVE screen.
Press the key, and then press
the key while is shown on
the display.
The MENU will appear. Point the
arrow at
+CONFIG using the dial or
UP/DOWN key, and then press the key.
The CONFIG menu will appear. Point the arrow at +BATT
SAVE and then press the key.
The BATT SAVE screen will appear.
2
Select an ON/OFF ratio for the battery saving feature.
Point the arrow at the desired ON/OFF ratio using the dial or UP/DOWN key, and
then press the key (the initial setting is NORMAL ).
The display will return to the CONFIG menu. Point the arrow at END and then
press the key (Alternatively, you may press the key, and then press
the key while is shown on the display).
Note: • If you exit the CONFIG menu by pressing the key, the changed
setting will be canceled.
• If LONG is selected, the time to keep the internal power source OFF
becomes longer. This extends the battery life, but delays receiving
reaction.
CLR
SKIP
F
ENT
TF
ENT
TF
ENT
TF
ENT
TF
HELP
SET
F
MODE
AUTO M
W
MIC
SCRT
PRIO
REC
CTCSS
F TUNE
A-B S
M NAME
TF
SKIP
STEP
ATT
SET
POW ER
PMS
VFO
MR M W
A B
SET
KL
3
6
9
8
0
5
2 1
4
CLR
ENT
SCN
RF C
HELP
7
MON
I
F
SRCH
LAMP
SQ
L
V
O
L
D O W
N
U
P O F F
SHOR T
BATT SAVE
ENT
TF