9 displaying battery voltage, 10 setting the reception tone, The battery voltage can be displayed as follows – Alinco DJ-X2000 User Manual
Page 40: 4 . 9 v
39
3.1.9 Displaying battery voltage
The battery voltage can be displayed as follows:
1
Call up the BATT VOLT screen.
Press the
key, and then
press the
key while
is
shown on the display.
The MENU will appear. Point the
arrow at
+CONFIG
using the dial or
UP/DOWN
key, and
then press the
key. The CONFIG menu will
appear. Point the arrow at
+BATT VOLT
using the dial
or
UP/DOWN
key, and then press the
key.
The battery voltage will be shown on the display.
If you press the
key, the display will return to the
CONFIG menu.
Note:
• The measured value is updated every 0.5 second.
• If an external power source (10-16 V) is used, “OVER 8V” is displayed.
3.1.10 Setting the reception tone
The reception tone can be set to either of 2 levels as follows:
1
Call up the TONE screen.
Press the
key, and then press
the key
while
is
shown
on the display.
The MENU will appear. Point the
arrow at
+CONFIG
using the dial or
UP/DOWN
key, and
then press the
key.
The CONFIG menu will appear. Point the arrow at
+TONE
and then press the
key.
The TONE screen will appear.
2
Set the reception tone.
Point the arrow at
High
or
Low
using the dial or
UP/DOWN
key, and then press
the
key (the initial setting is
High
).
The display will return to the CONFIG menu. Point the arrow at
END
and then
press the
key (Alternatively, you may press the
key, and then press the
key while
is shown on the display).
Note:
If you exit the CONFIG menu by pressing the
key, the changed setting
is canceled.
CLR
SKIP
ENT
TF
F
ENT
TF
ENT
TF
ENT
TF
ENT
TF
HELP
SET
F
MODE
AUTO MW
MIC
A-B S
M NAME
STEP
ATT
SET
POW
ER
PMS
VFO
MR M
W
A B
SET
KL
3
6
2
1
RF C
HELP
MONI
F
SRCH
LAMP
SQL VOL
DOWN UP
CLR
SKIP
ENT
TF
ENT
TF
HELP
SET
F
MODE
AUTO MW
MIC
A-B S
M NAME
STEP
ATT
SET
POW
ER
PMS
VFO
MR M
W
A B
SET
KL
3
6
2
1
RF C
HELP
MONI
F
SRCH
LAMP
SQL VOL
DOWN UP
B
4 . 9 V
A T T V O L T
H i g h
L OW
TONE