Alinco DJ-X2000 - Manual (Page 34)

33
Note: In the PMS or MR mode, setting DIRECT WR to ON enables selection of a
frequency step and modulation mode and adjustment of the attenuator and
CTCSS decoders. For further details, see “3.1.30 Directly changing the
settings” (page 60).
If AUTO STEP is selected, the most suitable frequency step for the received
frequency band will be automatically selected.
If USER STEP is selected, a frequency step can be selected freely in a range
between 50 Hz and 499.95 kHz.
Example: To enter 150 kHz, press: , , , ,
To enter 450 kHz, press: , , , ,
Even if a frequency that cannot be divided by the selected
step is entered, it is accepted. In this case, however, the
beep sound is emitted and “S” appears on the display
showing that the DJ-X2000 is operating in non-standard
steps.
3.1.3 Attenuating interference from
other channels (ATT)
The attenuator reduces interference from strong signals on other channels so
that the signal you want is heard more clearly.
1
Call up the ATT menu.
Press the key, and then press
the key while is shown on
the display. The ATT menu will
appear.
2
Selecting an attenuation level
Point the arrow at the desired attenuation level using the dial or UP/DOWN key
(the initial setting is OFF ).
OFF Turns the attenuator OFF.
LOW Attenuates the affected signals by approx. 10 dB.
HIGH Attenuates the affected signals by approx. 20 dB.
ATT will appear on the display showing that the attenuation function is turned
ON.
3
ATT
F
MODE
AUTO MW MIC A-B S
M NAME STEP
ATT
SET
POW ER
PMS
VFO
MR M W
A B
SET
KL
3
6
2 1 RF C
HELP
MONI
F
SRCH
LAMP
SQL VOL
DOWN UP
ENT
TF
5
AUTO MW
4
MIC F TUNE
0
REC
ENT
TF
5
AUTO MW
1
MODE F TUNE
0
REC
N
A 8 1 .
b 1 4 5 . 3 4
FM
O F F
L OW
ATT