16 setting scan signal level – Alinco DJ-X2000 User Manual
Page 44
43
3
Select a scanning option.
Point the arrow at the desired option using the dial or
UP/DOWN
key, and then
press the
key. The available scanning options are described below (the
initial setting is
BUSY
):
BUSY
Busy scan. The DJ-X2000 stays on any signal it locates until
the signal vanishes. Once the signal disappears, scanning is
resumed.
STOP
The DJ-X2000 stops scanning on the first signal it locates.
Scanning is not resumed after the signal vanishes.
TIMER
When the currently transmitted signals of any frequency are
received, scanning is paused for a given period of time. After
this specific time period, scanning is resumed even if the
signals are being received. For setting the pause period, see
“3.1.17 Setting the scanning pause period” (page 44).
The display will return to the SCAN menu. Point the arrow at
END
using the dial
or
UP/DOWN
key, and then press the
key (Alternatively, you may press the
key, and then press the
key while
is shown on the display).
Note:
If you exit the SCAN menu by pressing the
menu, the changed setting
is canceled.
3.1.16 Setting scan signal level
This setting specifies the minimum signal level used in scanning. Scanning will
stop only when the DJ-X2000 locates a signal of this strength or stronger.
1
Call up the SCAN menu.
Press the
key, and then press
the key
while
is
shown
on the display.
The MENU will appear. Point the
arrow at
+CONFIG
using the dial or
UP/DOWN
key, and
then press the
key.
The CONFIG menu will appear. Point the arrow at
+SCAN
and then press the
key.
The SCAN menu will appear.
2
Call up the S_LEVEL screen.
Point the arrow to
+S_LEVEL
using the dial or the
UP/DOWN
key, and then press the
key.
The S_LEVEL screen will appear.
ENT
TF
ENT
TF
ENT
TF
HELP
SET
MODE
AUTO MW
MIC
A-B S
M NAME
STEP
ATT
SET
POW
ER
PMS
VFO
MR M
W
A B
SET
KL
3
6
2
1
RF C
HELP
MONI
F
SRCH
LAMP
SQL VOL
DOWN UP
CLR
SKIP
ENT
TF
ENT
TF
ENT
TF
SCAN MODE
BUS Y T i me r
SCAN
S
O F F
ON
1
LEVEL
F