Alinco DJ-X2000 - Manual (Page 51)

50
2
Select the Flash tune.
Point the arrow at the desired option using the dial or UP/DOWN key, and then
press the key (the initial setting is FLASH TUNE ).
FLASH TUNE Instantaneously checks for a radio frequency and
automatically tunes in to the detected frequency.
F. COUNTER Checks for a radio frequency and shows the detected
frequency in real time (the frequency resolution is
100 Hz).
The display will go back to the CONFIG menu. Point the arrow at END, and then
press the
key (or alternatively, press the key, and then press the
key while is shown on the display).
Note: • If you exit the CH SCOPE menu by pressing the key, the changed
setting is canceled.
• Starting the Flash tune
Press the key, and then press the key while
is shown on the display. The Flash tune will start.
Pressing the key cancels the Flash tune.
Note: • The operating frequencies in the FLASH TUNE and F. COUNTR modes
ranges from approximately 50 MHz to 1300 MHz. The Flash tune starts
with input of approximately -30 dB or more. However, if there is any strong
radio or noise than the targeted radio, the Flash tune may not be activated
depending on the frequency condition.
• This function is not applicable to intermittent radio in intervals of 0.1 second
or less, such as digital radio.
• The Flash tune is not valid for radio that fluctuates by 1 kHz or more.
• If the Flash tune is set during scanning in the PMS or MR mode, the
scanning is canceled.
CLR
SKIP
F
MODE
AUTO MW MIC
SCRT PRIO
REC
CTCSS
F TUN E
A-B S
M NAM E
TF
SKIP
STEP
ATT
SET
POW ER
PMS
VFO
MR M W
A B
SET
KL
3
6
9
8
0
5
2 1
4
CLR
ENT
SCN
RF C
HELP
7
MON
I
F
SRCH
LAMP
SQL VOL
DOW
N UP
CLR
SKIP
ENT
TF
F ENT
TF
ENT
TF
F TUNE