Alinco DJ-X2000 - Manual (Page 17)

16
1.5.3 Ni-Cd battery charger
The supplied battery charger (EDC-88) is designed exclusively for use with our
NiCd battery pack.
Precautions in using the charger
1. The battery charger is designed exclusively for use with our NiCd battery
pack. Never use it to recharge any other rechargeable battery or dry cell.
2. Do not use the battery charger as a power source for any appliance.
3. Do not disassemble the battery charger.
4. Do not put any metal piece or wire in the battery charger, nor short-circuit the
recharging terminals.
5. Do not use the battery charger in a location where the temperature rises high,
e.g., near a heater or under direct sunlight, or where the dust or humidity level
is high.
• Parts designation and function
➀
Lamp
Indicates the status of the battery charger.
➁
Recharging terminals
Used for recharging the battery pack.
➂
AC power socket
Used to plug the AC power cord.
➃
AC power cord
Used to supply AC power.
➄
Guides (on the right and left sides)
Used to guide the transceiver when
inserting it into the battery charger.
Lamp status
Illuminated in red
Illuminated in green
Blinking in green
Blinking in red
Blinking alternately
in red and green
Battery charger status
Quick recharge is in progress.
Supplemental recharge is in progress.
Supplemental recharge is completed.
Supplemental recharge is in progress for
the completely discharged battery pack.
An irregular battery pack is in place.
Handling the battery pack
Leave it until it has been
recharged completely.
It may be removed.
Remove it.
Leave it until it has been
recharged completely.
Remove it immediately.