ACTi Camera Firmware V.5.12.12 - Manual (Page 76)

www.acti.com
Firmware User ’s Manual V5.12.12
76
also be activated this way. The event period will end when the camera returns to day mode,
which will then reset the camera to the original settings.
Device boots completely : This will trigger the event responses once the device boots up. You
can use this to create a notification system that keeps record of when the device has been
rebooted via email.
Reboot device : This triggers the event response when the device is shut down via web UI “Save
and Reboot ”. Use this to keep record of when was the device setting edited. Note that this will not
take effect when the device is unplugged, as this is not normal shutdown.
What responses will occur?
Digital Output (selected models only): This is an useful link to other devices. Click to include this
in the response for this rule.
Send notification Message : Select from the three pre-defined messages which you ’ve setup in
the Event Configuration section. You may enable multiple messages at the same time. For
sending Email, please limit the recipient to one per event rule. If you need to send email to more
than one recipient, please use separate event rules triggered by the same trigger.
Upload video/snapshots : Select which of the event configurations to include in this response
set. If you are sending email via upload video and sending notification message at the same time,
the system will automatically merge the two emails into one. The subject and image will be based
upon the Upload snapshot Event configuration enabled, but the message in the body text will be
based upon the Notification messages.
In general, please stick to the “one email per event rule” limit for best performance.
Change Motion Detection profile : This will switch the profile of the selected Motion Detection
region from Runtime profile to Event profile. The profile will return to runtime settings at the end of