ACTi Camera Firmware V.5.12.12 - Manual (Page 40)

www.acti.com
Firmware User ’s Manual V5.12.12
40
ePTZ Mode
ePTZ mode of Hemispheric Camera works in similar way as optical PTZ function in Speed
Domes. As the camera receives commands from remote client, it changes the direction of the
view or zooms in or out digitally. The stream coming out from the camera represents current
viewing direction of the camera, not the panoramic view.
The resolutions are available include 4M 2032 x 1920, Full HD 1920 x 1080, HD720 1280 x 720
and 640 x 480.
If you are using hemispheric camera in ePTZ mode,
this screen is available by clicking on PTZ button in the
live view screen . Mouse PTZ is enabled at the same
time.
You can configure up to 32 Zoom presets below. Just
click Set, enter the name and move position to what
you desire, then click set again. You can instantly ask
the camera to go to that zoom and focus position by
clicking on the Goto button.
Click Delete to remove this zoom preset point from
camera memory.
You can use ePTZ in live view by moving the mouse
over video and clicking on the video anywhere you like. Wherever you click, that point will
become new “center” of the view. This is how you “pan” and “tilt”. You also
can rotate the view via PTZ panel if you like.
To zoom in or out under ePTZ mode, use the scroll wheel of the mouse
Preset Tour
After you set the Preset Point, the Tour function will be enabled. Please refer Preset Tour ,
Note : Home position has to be set again after changing the installation type, the motion detection
configurations and PTZ configurations like preset points.