ACTi Camera Firmware V.5.12.12 - Manual (Page 66)

www.acti.com
Firmware User ’s Manual V5.12.12
66
To setup HTTP servers, make sure to enable the HTTP server, enter the user name,
the user password, Network (HTTP Server) address, Network (HTTP Server)
port number and Max connection time before timeout ( in seconds). Click [Apply] to use
these settings or click [Reset] to clear changes.
Event Configuration
Event configurations are the responses to be performed when an event is triggered. For most
types of responses, you can create several different preset responses, then mix and match in
event rules. Some responses are not supported in all IP devices (e.g.: DO, PTZ). Event Motion
Detection profile is also a triggerable response, but the parameters are defined through the Video
Adjust page, not in Event page.
The configurable responses are classified as Digital I/O ports, Notification messages, Upload
Image / Snapshot, Send URL Commands and go to PTZ Presets.
Digital I/O ports
Digital I/O ports (selected models only) read and control the voltage difference in the circuit,
and respond to it. They are useful in connecting to a wide variety of devices. D/I is a trigger, while
D/O is a response. Both are setup here. Both have a low voltage state and a high voltage state,
noted as 0 and 1.