beautypg.com

ACTi Camera Firmware V.5.12.12 User Manual

Page 71

background image

www.acti.com

Firmware User

’s Manual V5.12.12

71

Upload Period

: IP device will provide video/snapshots for the number of seconds here. It will

stop uploading video/snapshot at the end of this period. If you have video management software

recording from this camera at the same time, the normal recording through NVR will not be

affected, and goes on through out the event period and afterwards. But the special upload

session will end as the event ends.

Image during Upload Period:

This is used only by snapshots. This tells the camera how many

snapshots it should attempt to capture during the Upload Time. If this value is set to 0, then the IP

device will attempt to capture as many snapshots as possible. Depending upon the device

loading, the number of snapshots taken may not reach the number you specified.

Pre-Buffer Time

: This is only used by video. If this is set to more than 0, then the IP device will

start to buffer video in its internal memory. The maximum pre buffer is 3 seconds. When an event

requires video upload, the IP device will first upload the video taken right before the event then

keep uploading until it reaches the upload time.

Image File Name/ Upload Path

: You will need to specify rule for file names and upload paths

(upload path is not needed for Email. Just put a slash

“/” in the field). The rules contain flexible

parameters. A sample rule and corresponding filename will look like this:

Front_Door_%YYYY_%MM_%DD@%hh%mm%ss

[email protected]

Upload Path folders may also be named dynamically. For the IP device to create folders on FTP

and HTTP CGI servers properly, your FTP/CGI account will need to have permission to create

folders. For syntax on auto naming, please see online help or the inset box at the end of this

section.

The symbol

“%” cannot be the first character in filename or upload path. Please use either an

alphabet or a number as the starting character. For Upload Path, be sure to start and end eith a

backslash

“\”. An example will be : \Backgate%MM%DD\

CGI path & Program

: Some CGI servers may require special info and settings. Please refer to

CGI server designer for this section. IP devices do not allow upload of Snapshots / Video into

their embedded CGI servers.

E-Mail Recipient / Subject

: When uploading video/ snapshots via email, these information are

required.