Welltech SIPPBX 6200 V.3.1.0 - Manual (Page 78)

Welltech Computer Co., Ltd.
SIPPBX 6200S/GS Release 3.1.0 User Guide - 78 -
4. Direct Fax in number: Create a new extension as the fax DID number
and enable unconditional forward to “FAX Prefix+Extension”.
The Caller can send fax by dialing this fax number directly.
The received FAX messages will be stored as PDF format.
The fax message can be retrieved through web interface or send a email
to the user with the fax PDF attachment.
• Send T.38 Re-invite Delay (sec): The delay to send re-invite for T.38 after
call connected.
• T.38 Re-invite Accept Timer(sec): The timer for waiting 200 OK after the
T.38 re-invite. When timeout is happened, the call will be disconnect.
• Use ECM: Enable or disable the Error Correction Mode for FAX service
• UDPTL EC Entry Count: The T.38 redundant depth. The default value is 2.
• Max Operation Timeout(sec): The maximum operation time in seconds.
The SIPPBX 6200 will disconnect the FAX call automatically if the FAX IN
time over than it.
Device Auto Configuration
The SIPPBX 6200 provided the Extension Device Auto Configuration feature.
System Administrator can easy managing the extension device without setup.
Most of setting can be automatic provisioned to CPE
(current support LP600N
only) .
Here you can set the Extension Auto Configuration parameters.
The following parameters will be provisioned to
- SIPPBX discovery (when using VLAN and DHCP)
- Telephone number and PBX related setting
- Access code required for LP600N
- Office and personal phone book
- Office dialing plan
- Common Device Configuration
- Firmware
Upgrade
The most settings were full integrated into SIPPBX configuration. Here is for
the device (LP600N)’s common configuration and firmware upgrade.