Verilink AS2000: The Basics (880-502981-001) Product Manual - Manual (Page 97)

System Cables
Verilink Access System 2000: The Basics B-3
Figure B-1 RS–232 Craft Cable
120 Ohm, DE-09
Network Crossover Cable
458-502649-008 8 ft/243.8 cm Figure B-21, “120 OHM, DE-09—
DE-09 Network Crossover
Cable”
RJ-48/DB-15 T1 100
Ohm Network Cable
458-501768-008
458-501768-020
458-501768-050
458-501768-100
8 ft/243.8 cm
20 ft/609.6 cm
50 ft/1524 cm
100 ft/3048 cm
Figure B-22, “RJ-48/DB-15 T1
100 OHM Network Cable”
RJ-48/RJ-48 T1 100 Ohm
Network Cable
458-501769-008
458-501769-015
458-501769-020
458-501769-030
458-501769-050
458-501769-100
8 ft/243.8 cm
15 ft/457.2 cm
20 ft/609.6 cm
30 ft/914.4 cm
50 ft/1524 cm
100 ft/3048 cm
Figure B-23, “RJ-48/RJ-48 T1
100 OHM Network Cable”
Description Part Number Length Illustration
J1 P1
NC
SGND
TX
RX
FEMAL J1
P1
DRAIN
6
1
14
25
1
13
NC
MOD
DTE DTE
DRAIN
Part Number 458-501788-008 (8 ft.)
6 PIN MINI DB-25
2
3
7
TX
RX
SGND
1
2
3
4
5
6
1. The Craft cable provides a connection between an AS2000 module and a dumb
ASCII terminal. This cable is required to access the CraftI (ASCII) interface used to
configure the module, and to monitor network performance.
2. This cable is used on all Verilink node controllers and ACE cards.
(N/C Indicates no connection
Note: Contact Verilink Technical Assistance Center for a craft cable with a DB9 connector.