Teac DR-44WL Reference Manual - Manual (Page 19)

TASCAM DR-44WL
19
4 – Recording
CAUTION
• Confirm that phantom power is OFF before connecting a
line level device to the EXT MIC/LINE IN jack. If you connect
a line level device while phantom power is being supplied,
that device and this unit could be damaged.
• When connecting to or disconnecting a condenser micro-
phone from the EXT MIC/LINE IN jack, confirm that the
phantom power for that jack is OFF. If you connect or
disconnect a microphone while phantom power is being
supplied, that microphone and this unit could be damaged.
• Turn phantom power ON only when using a condenser
microphone that requires phantom power.
• Supplying phantom power to some ribbon microphones
will break them. If you are unsure, do not supply phantom
power to a ribbon microphone.
• When using USB bus power, the unit might not be able to
supply phantom power depending on the computer. If this
occurs, use the dedicated AC adapter (GPE053B) supplied
with the unit instead.
• Some condenser microphones will not operate when
phantom power is set to +24V.
• Do not connect or disconnect the AC adapter when using
phantom power. Even when the battery were inserted in
the unit, the power might be cut off, causing data being
recorded to be damaged or lost.
Settings in the “INPUT SETTING”
screen
The contents of the
INPUT SETTING
screen displayed by
pressing the INPUT button vary depending on which mode to
be selected between 4CH mode and MTR mode.
INPUT SETTING
screen Tr1 display when in 4CH mode
INPUT SETTING
screen Tr1 display when in MTR mode
NOTE
Change the setting for LINK in the track display to ON and
the content displayed in the lower part of the
INPUT
SETTING
screen changes.
INPUT SETTING screen Tr1 display when in 4CH mode