Teac DR-44WL Reference Manual - Manual (Page 14)

14
TASCAM DR-44WL
3 – Preparation
Resume function
The DR-44WL is equipped with a resume function to locate the
previous position (or time) when the power was turned off.
Turn the power on and press the 7/9 button to play back
from the previous file position (time) when the power was
turned off.
NOTE
The position is recorded in the SD card. The resume function
does not work if the SD card is replaced or formatted.
Setting the date/time
The DR-44WL uses its internal clock to record the date and time
to the recorded files.
1. Press the MENU button to open the
MENU
screen.
2. Using the wheel, select (highlight) SYSTEM menu item
and press the ENTER/MARK or / button.
The
SYSTEM
screen is displayed.
3. Using the wheel, select (highlight)
DATE/TIME
and
press ENTER/MARK button.
4. Press the ENTER/MARK button again to display the
DATE/TIME screen.
5. Press the . button or / button to move the cursor
(highlighted area), and use the wheel to change values.
6. Press the ENTER/MARK button to confirm the change and
return to the SYSTEM screen.
NOTE
The file name will include the set date/time. (see “Setting the
file name type” on page 52)
CAUTION
The date and time setting can only be maintained for a few
minutes if the battery power becomes low or the unit is not
powered by the dedicated AC adapter (GPE053B) included
with the unit or USB cable.
When using batteries, we recommend to replace them
before they are completely drained.
Inserting and removing SD cards
Inserting the SD card
NOTE
When the product is purchased, the SD card slot has an SD
card already installed. If you want to use this SD card to
record and play tracks, there is no need to reinstall it.
1. Open the SD card slot cover on the left side panel.
2. Insert the SD card into the slot as shown in the following
illustration until it clicks into place.
Removing the card
1. Open the SD card slot cover.
2. Press the SD card in gently and then release it to allow it to
come out.
CAUTION
• Do not remove the SD card from the unit during recording,
playback or at other times when it is being accessed.
• Do not remove the SD card from the unit when it is
connected to a computer via USB.
• SD cards that meet SD, SDHC or SDXC standards can be used
with this unit.
• A list of SD cards that have been confirmed to work with
this unit can be found on the TEAC Global Site (http://
teac-global.com).