Teac DR-44WL Reference Manual - Manual (Page 15)

TASCAM DR-44WL
15
3 – Preparation
SD card write protection switches
An SD card comes equipped with a write protect switch.
Unprotected Protected
If you slide the protect switch to the LOCK position, file
recording and editing is not possible. Move the switch to the
unlocked position in order to record, erase and otherwise edit
data on the card.
Preparing an SD card for use
In order to use an SD card in this unit, you must format it first.
1. Confirm that an SD card is installed and turn the power ON.
2. The following message appears when a new card or a card
formatted by another device is inserted into the unit.
3. Press the ENTER/MARK button to start formatting.
CAUTION
Formatting will delete all data from the card.
4. When formatting is complete, it will return to the Home
screen. You may format the card whenever required.
CAUTION
When formatting the SD card, make sure the unit is
connected to the dedicated AC adapter (GPE053B) included
with the unit, a computer via USB bus power, or fully-
charged batteries.
Turning the built-in speaker on/off
The factory setting for the built-in speaker output is selected as
ON. To turn it off, open the TOOLS screen and select ON for
the SPEAKER setting.
1. Press the MENU button to open the
MENU
screen.
2. Using the wheel, select (highlight)
TOOLS
menu item and
press the ENTER/MARK or / button.
TOOLS screen appears.
3. Using the wheel, select (highlight)
SPEAKER
and press
the ENTER/MARK or / button.
4. Using the wheel, turn on or off and press the ENTER/MARK
button.
Options:
OFF
,
ON
(default setting)
5. Once the setting has been completed, press the 8/HOME
button to return to the Home screen.
NOTE
In a recording standby or recording mode, or when a
headphone or a speaker system is connected to the
DR-44WL, the built-in speaker will not emit sound even
when the
SPEAKER
setting is
ON
.
Connecting a monitor device
To listen with a headphone, connect it to the /LINE OUT jack.
External monitor system (powered monitor speaker or an
amplifier and speaker): connect the external monitor system to
the /LINE OUT jack.
Headphone
Powered speakers
or
Amplifier and speaker
Adjusting the playback volume
When the Home screen is being displayed, use the OUTPUT
LEVEL (+/−) button on the left side panel to adjust the volume
of output through the built-in speaker or the /LINE OUT jack.
A volume level indicator will pull up at the bottom of the display.