RLE LD2000 User Manual
Page 26

www.rletech.com
26
970.484.6510
3
Installation
The Network/IP Configuration page displays.
2
Enter the values for IP Address, Net Mask (subnet mask), and Def Route (default gateway)
provided by your IT administrator.
Once you enter the values and click the Submit Changes button, the LD2000 saves the
changes and reboots. The system status LED on front of the LD2000 stops flashing.
3
Reset the computer to its original IP address and subnet mask.
Note
This step might require assistance from your IT administrator.
The computer and the LD2000 are now both configured to communicate on the network.
4
From the computer’s Web browser, go to the new IP address of the LD2000.
5
When prompted, enter the user name and password to verify network access to the LD2000
(as you did in step 4 in the previous section).
If the login window for the LD2000 does not display:
a
Verify that the cables are firmly attached.
b
Verify that you entered the correct IP address for the LD2000.
c
Verify that the Status light on the top of the LD2000 is green.
For troubleshooting and additional configuration information, consult the LD2000 User Guide
available at www.rletech.com
LD2000 Default Values
IP address: 10.0.0.188
Subnet mask:
Use values provided
by IT administrator