Mechanical description, Installation, Reference map – RLE LD2000 User Manual
Page 14: Web interface
www.rletech.com
14
970.484.6510
1
Product Overview
1.3. Mechanical
Description
The LD2000 is built with one circuit board. The main board is mounted inside of the
enclosure. A reset switch is provided inside of the enclosure on the board to reset the
microprocessor without cycling power to the unit.
1.4. Installation
The LD2000 is a wall-mounted device. Before applying power to the unit, ensure that all
connections are correct and all screw terminals are secure. The LD2000 is powered by 24
VAC or 24 VDC power. DO NOT connect 120/230 VAC to the unit, or damage will occur to
the circuitry.
1.5. Reference
Map
Users are advised to purchase a framed reference map (part #FM1114) for use with the
LD2000 to help locate any detected leaks along the sensing cable; to view a sample map, go to
the SeaHawk Accessories we
. Once all the sensing cable is
installed, compare this reference map with the actual cable installation. Note any discrepancies
and return the map to the original author for correction. Keep a copy for use until the map is
revised.
1.6. Web
Interface
The LD2000's webpage interface provides remote information updates via network
communications. The interface's menu structure is as follows:
Home
–
Alarm Status
–
Cable Length
–
Cable Current
–
Leg 1 Resistance
–
Leg 2 Resistance
–
Alarm Delay Counts
–
Last Alarm Time
–
Model
–
Flash Application
–
Flash Appl. Size
–
Bootloader Version
–
MAC Address
–
IP Address