REMKO HTS 90 ALU - Manual (Page 65)

ID Description Desig
.
Details
ID8111 Device offline
Device offline - please check the data connection between the
controller board and the inverter
ID8132 Anti-freeze protection
active
The anti-freeze protection function is currently active - check
the room climate mode set
ID8138 HW storage tank set
temp.
The hot water storage tank set temperature was reduced due
to low outside temperatures
ID8139 Lower application area
(heating)
The temperature has currently dropped below the guaranteed
application area of the external unit in heating mode
ID8140 Upper application area
(heating)
The guaranteed application area of the external unit in heating
mode is currently exceeded
ID8141 Lower application area
(cooling)
The temperature has currently dropped below the guaranteed
application area of the external unit in cooling mode
ID8142 Upper application area
(cooling)
The guaranteed application area of the external unit in cooling
mode is currently exceeded
ID8144 Target flow rate (I/O 2) The flow rate has dropped below the target flow rate
ID8223 SD card error (host)
SD card error (host): The SD card is either not inserted cor-
rectly or an error has occurred
ID8224 SD card error
SD card error (CP): The SD card is not inserted or an error has
occurred
ID8225 Dewpoint monitoring CP
Dew point monitoring was activated but no control panel (with
integrated humidity and temperature probe) was assigned to
the cooling cycle to calculate the dew point
ID8226 Temp. dropped below
min. inlet temp.
Temp. dropped below min. inlet temp. (or dew point) - cooling
request is suppressed
ID8227 Hygiene function:
Setpoint not reached
The hygiene function was cancelled due to the maximum run-
time being reached before attaining the set temperature
ID8229 2. heat generator active
Due to the return temperature being too low during defrosting,
the 2nd heat generator activated
65