REMKO HTS 90 ALU - Manual (Page 55)

10 Electrical wiring
10.1 Important notes
You can find information on the electrical con-
nections of the indoor and outdoor unit, on the
terminal assignment of the I/0 module, as well
as on the circuit diagrams in the separate
"Electrical wiring" operating instructions
NOTICE!
For an existing block the heat pump by the
utility (utility switching) must be used the con-
trol contact S 16 of the Smart-Control.
11 Commissioning
11.1 Control panel and
information on commissioning
The Smart Control is used to operate and control
the entire heating system. The Smart Control is
operated from the operating unit. The operating
unit is positioned on the basic device.
n The unit is pre-installed at the factory. After a
reset of the Smart Control, the default parame-
ters are loaded.
n An intensive visual inspection is to be carried
out before the actual commissioning.
n Switch on the power supply.
n Then the preinstalled data is loaded and the
parameters can be set with the help of the
commissioning wizard or in the system configu-
ration. You can find information on this in the
separate operating instructions of the Smart
Control.
NOTICE!
Before commissioning the domestic water
storage will be filled.
55