REMKO HTS 90 ALU - Manual (Page 32)

frost proof. The outdoor module consists only of
the plate condenser, the fan and the fan motor.
This means that the outdoor unit is considerably
smaller. The indoor module contains the con-
denser of the refrigerant circuit, an electronic
expansion valve, filter dryer, refrigerant chamber
and connections for the heating network.
REMKO inverter technology
The heat pump's compressor is equipped with are
equipped with a speed control system, as needed.
The power control on conventional heat pumps
provides only two states, either ON (full output) or
OFF (no output). The heat pump turns on below a
specified temperature and turns off when this tem-
perature is reached. This kind of heat regulation is
very inefficient. Heat regulation in the REMKO
inverter heat pump is modulated to the actual need
and is adjusted to suit actual needs. The elec-
tronics system has an integrated frequency-con-
verter which serves to modify the condenser speed
and the speed of the blower as required. The con-
denser works at a higher speed when under full
load than under partial load. The lower speeds
ensure a longer operational lifetime for the compo-
nents, improved coefficient of performance and
lower noise. Lower speeds also result in lower
energy consumption (electricity) and longer service
life. i.e.: inverter heat-pumps will run practically
throughout the heating season. In all, the highest
efficiency possible.
1/3
When it is switched on, the inverter only requires
one-third of the time of conventional systems
Time
Minimal temperature fluctuations
mean energy savings
Conventional
Inverter
Temperature
Fig. 10: Modern inverter technology
REMKO HTS
32