OWON MSO Series - Manual (Page 48)

43
mode is used to observe two unrelated signals. You can choose different trigger modes
for different channels. The options are as follows: edge, video, pulse or slope.
Alternate trigger(Trigger mode: Edge)
Alternate trigger(Trigger Type: Edge) Menu is shown as Fig.5-23 .
Fig.5-23 Alternate trigger(Trigger Type: Edge) Menu
Alternate trigger(Trigger Type: Edge) Menu list:
MENU SETTING INSTRUCTION
Source
CH1
CH2 Channel 1 as the trigger source.
Channel 2 as the trigger source.
Mode Edge Set vertical channel trigger type for edge trigger.
Slope
Rising
Falling
Trigger on the rising edge.
Trigger on the falling edge.
Coupling
AC
DC
HF
LF
Block the direct current component.
Unblock all components.
Block the high-frequency signal and only unblock the
low-frequency component.
Block the low-frequency signal and only unblock the high
-frequency component.
Holdoff 100ns～10s
Set interval by using TRIG LEVEL control, value range
from 100ns～10s.
Holdoff
Reset
Reset hold time to 100ns
Alternate trigger(Trigger Mode: video)
Alternate trigger(Trigger Type: video) Me nu is shown as Fig.5-24 .