OWON MSO Series - Manual (Page 47)

42
Slope Trigger
Slope trigger sets the oscilloscope as the positive/negative slope trigger within the
specified time.
The Slope Trigger Menu is shown as Fig. 5-22 .
Fig. 5-22 Slope Trigger menu
Slope Trigger menu list
MENU SETTING INSTRUCTION
Source
CH1
CH2 Channel 1 as the trigger source.
Channel 2 as the trigger source.
Mode Slope
When
Set slope condition
Settings 24ns~10s Turn "TRIG LEVEL" knob to set slope time
High level Turn "TRIG LEVEL" knob to set the High level
Low level Turn "TRIG LEVEL" knob to set Low level
Slew rate Slew rate=( High level- Low level)/ Settings
Trigger
mode
Auto
Normal
Single
Acquire waveform whatever detect trigger condition or not
Only acquire waveform when match trigger condition
Only acquire waveform for single time when detect trigger
condition then stop.
Holdoff
100ns～
10s
Set interval by using TRIG LEVEL control, value range from
100ns～10s.
Holdoff
Reset
Reset hold time to 100ns
Alternate trigger
Trigger signal comes from two vertical channels when alternate trigger is on. This