OWON MSO Series - Manual (Page 106)

101
8. Technical Specifications
Unless otherwise specified, the technical specifications applied are applicable to the
probe with the attenuation switch setting 10X and the MSO series digital oscilloscope.
Only if the oscilloscope fulfill the following two conditions at first, can these
specification standards be reached.
 This instrument should run for more than 30 minutes continuously under the
specified operating temperature.
 If the change range of the operating temperature is up to or exceeds 5℃, open the
system function menu and execute the "Auto-calibration" procedure.
All specification standards can be fulfilled, except one(s) marked with the word
"Typical".
Digital Storage Oscilloscope
Performance Characteristics Instruction
Bandwidth
 60MHz----MSO7062TD
 100MHz----MSO7102TD,MSO8102T
 200MHz----MSO8202T
Channel 2 + 1 (External)
Acquisition：
Mode Normal, Peak detect, Averaging
Sample rate (real time)
 1GS/s half channel*, 500MS/s each
channel----MSO7062TD, 7102TD
 2GS/s half channel*, 1GS/s each
channel----MSO8102T, 8202T
Input：
Input coupling DC, AC , Ground
Input impedance
1MΩ±2%，in parallel with 15pF±5pF
Probe attenuation factor 1X，10X，100X，1000X
Max. input voltage 400V (PK-PK) （DC + AC PK-PK）
Bandwidth limit 20MHz、100MHz
Channel isolation
50Hz: 100 : 1
10MHz: 40 : 1
Time delay between
channel(typical)
150ps