Rover test setup – NavCom SF-2040 Rev.C User Manual
Page 87
LAND-PAK™ User Guide – Rev. C
4-83
Rover Test Setup
This section provides the steps to correctly and safely
set up the rover. It is important to select an open area
for the test setup.
An outdoor setup requires the transport of the rover
transit case and the rover bag, both of which contain
all the rover equipment.
The outer section of the rover pole is
carbon fiber. The inner extension is
aluminum, with dual graduations in
feet and meters.
The rover pole and bipod leg points
may damage so
ft materials, including
indoor carpets.
Over tightening attachment
carbon fiber of the rover pole may
s to the
cause damage.
The bipod is intended to make
installation easier, but it is not as
stable as a tripod.
d a safe,
1. Fi
open, and flat location to setup the
rover.
lowing steps use equipment from the rover
n
d
3.
gs.
The fol
bag:
2. Remove the strap that holds together the bipo
legs. Store the strap in the rover bag.
Position the bipod upright on the floor or ground.
Do not open the bipod le
- SF-3050 Logging Data to Internal Memory SurvCE (4 pages)
- SF-3040 Logging Data to Internal Memory or SD Card (6 pages)
- SF-3050 Logging Data to USB Using SurvCE (4 pages)
- StarFire over IP (5 pages)
- SF-3050 Quick Start (4 pages)
- SF-3050 A Computationally Efficient Ambiguity Resolution (7 pages)
- StarFire (5 pages)
- StarFire to SW v3.0.12.0 (3 pages)
- SF-3050 Rev.I (196 pages)
- StarUtil-3000 Rev.G (177 pages)
- Sapphire Rev.L (450 pages)
- StarUtil-3000 Rev.A (119 pages)
- SF-3050 Rev.A (169 pages)
- SF-3050 Rev.B (201 pages)
- SF-3050 Rev.D (235 pages)
- Rinex Utility Rev.D (17 pages)
- SF-3040 Quick Start (4 pages)
- SF-3040 Rev.F (217 pages)
- SurveCE Integration Rev.A (150 pages)
- Install Utility Rev.C (26 pages)
- LAND-PAK Quick Start Rev.B (7 pages)
- LAND-PAK Rev.E (156 pages)
- StarUtil Rev.C (58 pages)
- LAND-PAK Rev.N (194 pages)
- StarUtil Rev.B (8 pages)
- StarUtil Rev.F (134 pages)
- SF-2040 Rev.E (63 pages)
- RT-3010 Rev.E (61 pages)
- StarFire Satellite Change Rev.G (24 pages)
- StarFire Satellite Change Rev.I (23 pages)
- TS Collecting Receiver (2 pages)
- TS Factory Default (2 pages)
- LAND-PAK Rev.F (159 pages)
- SF-2040 Rev.F (93 pages)
- RT-3020 Rev.F (93 pages)
- SF-2110 Quick Start Rev.A (2 pages)
- StarPac Rev.A (15 pages)
- StarControl Rev.C (56 pages)
- SF-2050 Rev.F (99 pages)
- TruBlu Rev.A (2 pages)
- VueStar Rev.B (13 pages)
- SF-2110 Rev.B (99 pages)
- StarUtil-2110 Rev.A (85 pages)
- RT-3010 Rev.F (89 pages)