Rf frequency configuration, Figure 19: data transfer mode – NavCom SF-2040 Rev.C User Manual
Page 68
LAND-PAK™ User Guide – Rev. C
4-64
top of th
illuminat
e battery. The red LED
es.
During this initial configuration, the
signal strength setting in data transfer
mode is blank (see Figure 19).
Figure 19: Data Transfer Mode
programming mode. Press the Setup soft
e
2. Acc ss
key
e
sho
ver
n
app
r
RF requ
e
(s
ws
sio
lly
ea s (see Figure 18).
any time during configuration, press
Cancel/Back
Figure 19). The display temporarily
the radio modem model and the firmware
. Then the main menu automatica
At
the
soft ke
changes if necessary, t
previous scr
y to cancel
o return to a
een, or to exit the main
menu.
ency Configuration
F
nly to a
licensed frequency. It must comply
with local regulations.
A label on both radios lists the i
Set the radio modems o
nitial
(center) frequency. The label is on the
front of the base station radio. It is on
the rear of the rover radio, above the
battery. The frequency can be set
within 1MHz of the center frequency,
at 25KHz increments.
- SF-3050 Logging Data to Internal Memory SurvCE (4 pages)
- SF-3040 Logging Data to Internal Memory or SD Card (6 pages)
- SF-3050 Logging Data to USB Using SurvCE (4 pages)
- StarFire over IP (5 pages)
- SF-3050 Quick Start (4 pages)
- SF-3050 A Computationally Efficient Ambiguity Resolution (7 pages)
- StarFire (5 pages)
- StarFire to SW v3.0.12.0 (3 pages)
- SF-3050 Rev.I (196 pages)
- StarUtil-3000 Rev.G (177 pages)
- Sapphire Rev.L (450 pages)
- StarUtil-3000 Rev.A (119 pages)
- SF-3050 Rev.A (169 pages)
- SF-3050 Rev.B (201 pages)
- SF-3050 Rev.D (235 pages)
- Rinex Utility Rev.D (17 pages)
- SF-3040 Quick Start (4 pages)
- SF-3040 Rev.F (217 pages)
- SurveCE Integration Rev.A (150 pages)
- Install Utility Rev.C (26 pages)
- LAND-PAK Quick Start Rev.B (7 pages)
- LAND-PAK Rev.E (156 pages)
- StarUtil Rev.C (58 pages)
- LAND-PAK Rev.N (194 pages)
- StarUtil Rev.B (8 pages)
- StarUtil Rev.F (134 pages)
- SF-2040 Rev.E (63 pages)
- RT-3010 Rev.E (61 pages)
- StarFire Satellite Change Rev.G (24 pages)
- StarFire Satellite Change Rev.I (23 pages)
- TS Collecting Receiver (2 pages)
- TS Factory Default (2 pages)
- LAND-PAK Rev.F (159 pages)
- SF-2040 Rev.F (93 pages)
- RT-3020 Rev.F (93 pages)
- SF-2110 Quick Start Rev.A (2 pages)
- StarPac Rev.A (15 pages)
- StarControl Rev.C (56 pages)
- SF-2050 Rev.F (99 pages)
- TruBlu Rev.A (2 pages)
- VueStar Rev.B (13 pages)
- SF-2110 Rev.B (99 pages)
- StarUtil-2110 Rev.A (85 pages)
- RT-3010 Rev.F (89 pages)