Figure 11: navcom base cable – NavCom SF-2040 Rev.C User Manual
Page 54
LAND-PAK™ User Guide – Rev. C
4. Unplug the battery charger.
Male 15-Pin
Serial
Connector
LEMO 2-Pin
Connector
LEMO 7-Pin
Connector
Figure 11: NavCom Base Cable
Refer to Figure 11 for the steps below:
5. Verify the bag battery is fully charged. Power on
the radio modem to check the battery voltage:
a. Connect the serial 15-pin end of the NavCom
base cable to the female serial connector on
the bottom right of the radio modem.
b. Connect the LEMO 2-pin end of the base
cable to the bag battery. The radio modem
powers on. (The LEMO 2-pin connector is
fitted to the red fuse-fit and black cables.)
The LCD display shows the battery status and
other settings. The supply voltage is in the top
right (see Figure 17). A full charge is 13.5V to
14.70V.
The LEMO 7-Pin end of the base
cable is not used in this procedure.
6. Disconnect the bag battery if it is fully charged.
4-50
- SF-3050 Logging Data to Internal Memory SurvCE (4 pages)
- SF-3040 Logging Data to Internal Memory or SD Card (6 pages)
- SF-3050 Logging Data to USB Using SurvCE (4 pages)
- StarFire over IP (5 pages)
- SF-3050 Quick Start (4 pages)
- SF-3050 A Computationally Efficient Ambiguity Resolution (7 pages)
- StarFire (5 pages)
- StarFire to SW v3.0.12.0 (3 pages)
- SF-3050 Rev.I (196 pages)
- StarUtil-3000 Rev.G (177 pages)
- Sapphire Rev.L (450 pages)
- StarUtil-3000 Rev.A (119 pages)
- SF-3050 Rev.A (169 pages)
- SF-3050 Rev.B (201 pages)
- SF-3050 Rev.D (235 pages)
- Rinex Utility Rev.D (17 pages)
- SF-3040 Quick Start (4 pages)
- SF-3040 Rev.F (217 pages)
- SurveCE Integration Rev.A (150 pages)
- Install Utility Rev.C (26 pages)
- LAND-PAK Quick Start Rev.B (7 pages)
- LAND-PAK Rev.E (156 pages)
- StarUtil Rev.C (58 pages)
- LAND-PAK Rev.N (194 pages)
- StarUtil Rev.B (8 pages)
- StarUtil Rev.F (134 pages)
- SF-2040 Rev.E (63 pages)
- RT-3010 Rev.E (61 pages)
- StarFire Satellite Change Rev.G (24 pages)
- StarFire Satellite Change Rev.I (23 pages)
- TS Collecting Receiver (2 pages)
- TS Factory Default (2 pages)
- LAND-PAK Rev.F (159 pages)
- SF-2040 Rev.F (93 pages)
- RT-3020 Rev.F (93 pages)
- SF-2110 Quick Start Rev.A (2 pages)
- StarPac Rev.A (15 pages)
- StarControl Rev.C (56 pages)
- SF-2050 Rev.F (99 pages)
- TruBlu Rev.A (2 pages)
- VueStar Rev.B (13 pages)
- SF-2110 Rev.B (99 pages)
- StarUtil-2110 Rev.A (85 pages)
- RT-3010 Rev.F (89 pages)