Figure 65: gps base submenu – receiver tab – NavCom SF-2040 Rev.C User Manual
Page 105
LAND-PAK™ User Guide – Rev. C
5-101
Refer t
4. Tap
o Figure 65 for the steps below:
the
Receiver tab.
bmenu – Receiver Tab
5. Set the options:
• Antenna Type: [NAVCOMSF2040G] GIS
• Antenna Height: Enter the height in the
current job units, and select Slant. Take the
slant height measurement at the center of the
black ring around the top of the receiver.
If working in feet, the height can be
checked by measuring in meters. Tap
the Antenna Height field. Enter the
this angle, no data will be transmitted to the
Figure 65: GPS Base Su
h
c
eight in meters, for instance 2.000m.
Tap outside the field. The meters are
onverted to feet.
• Elevation Mask: Enter the cutoff vertical angle
above the horizon. For any satellites below
rover for use in calculating positions.
The recommended setting for the
base receiver is 5 degrees; however,
the height of on-site obstructions will
- SF-3050 Logging Data to Internal Memory SurvCE (4 pages)
- SF-3040 Logging Data to Internal Memory or SD Card (6 pages)
- SF-3050 Logging Data to USB Using SurvCE (4 pages)
- StarFire over IP (5 pages)
- SF-3050 Quick Start (4 pages)
- SF-3050 A Computationally Efficient Ambiguity Resolution (7 pages)
- StarFire (5 pages)
- StarFire to SW v3.0.12.0 (3 pages)
- SF-3050 Rev.I (196 pages)
- StarUtil-3000 Rev.G (177 pages)
- Sapphire Rev.L (450 pages)
- StarUtil-3000 Rev.A (119 pages)
- SF-3050 Rev.A (169 pages)
- SF-3050 Rev.B (201 pages)
- SF-3050 Rev.D (235 pages)
- Rinex Utility Rev.D (17 pages)
- SF-3040 Quick Start (4 pages)
- SF-3040 Rev.F (217 pages)
- SurveCE Integration Rev.A (150 pages)
- Install Utility Rev.C (26 pages)
- LAND-PAK Quick Start Rev.B (7 pages)
- LAND-PAK Rev.E (156 pages)
- StarUtil Rev.C (58 pages)
- LAND-PAK Rev.N (194 pages)
- StarUtil Rev.B (8 pages)
- StarUtil Rev.F (134 pages)
- SF-2040 Rev.E (63 pages)
- RT-3010 Rev.E (61 pages)
- StarFire Satellite Change Rev.G (24 pages)
- StarFire Satellite Change Rev.I (23 pages)
- TS Collecting Receiver (2 pages)
- TS Factory Default (2 pages)
- LAND-PAK Rev.F (159 pages)
- SF-2040 Rev.F (93 pages)
- RT-3020 Rev.F (93 pages)
- SF-2110 Quick Start Rev.A (2 pages)
- StarPac Rev.A (15 pages)
- StarControl Rev.C (56 pages)
- SF-2050 Rev.F (99 pages)
- TruBlu Rev.A (2 pages)
- VueStar Rev.B (13 pages)
- SF-2110 Rev.B (99 pages)
- StarUtil-2110 Rev.A (85 pages)
- RT-3010 Rev.F (89 pages)