NavCom SF-2040 Rev.C - Manual (Page 67)

LAND-PAK™ User Guide – Rev. C
4-63
Configuration
The sections following provide steps to configure
these radio menu items:
9
RF Frequency
9
RF Power Output (set for base station only)
9
Signal Threshold (set for rover only)
Addressing Settings
Serial Port Settings
• Base Station Radio Modem:
• The LAND-PAK LM configuration (3ASd
Epic radio modem): There is no on/off
switch on the 3ASd Epic radio modem.
Connect the serial 15-Pin end of the
connector on the bottom right of the radio
modem. Connect the LEMO 2-Pin end to
ag battery (see Figure 11).
d
e LAND-PAK
nfigurations use the same
Turn on the switch at the
9
9
9
Additional
Handshaking
9
Configure the base station radio modem. Then repeat
the configuration steps for the rover radio modem.
1. Power on the radio modem:
NavCom base cable to the female serial
the b
• The LAND-PAK 869 configuration (3AS
869 radio modem): Turn on the switch at
the top of th
e battery. The red LED
s.
• Rover Radio Modem:
illuminate
• The rover radio modems in th
LM and 869 co
type of battery.