NavCom SF-2040 Rev.C - Manual (Page 70)

LAND-PAK™ User Guide – Rev. C
4-66
Figure 22: Set Frequency
Change the value of the last co d. nfigurable digit,
if needed.
e. Press the Set soft key to set the frequency
changes. Or, press the Cancel soft key to
cancel the changes.
• If the frequency is set within the
acce ation message
is disp en the main
e is
mporarily. Then the main
e
• If the frequency changes are canceled, the
display returns to the main menu.
4. Continue to the next section, to configure the RF
power output.
RF Power O
modem e rover radio modem is being configured,
go
1. Pre sor
Radio settings (see
Figure 23).
ptable range, a confirm
layed temporarily. Th
menu returns.
• If the frequency is set outside the
acceptable range, an error messag
displayed te
menu returns. No change is made to th
center frequency. Repeat the RF
frequency configuration procedure to
change the frequency.
utput
Perform this setting only on the base station radio
. If th
to the next section below, Signal Threshold.
ss the down arrow soft key to move the cur
down the main menu to