NavCom SF-2040 Rev.C - Manual (Page 57)

LAND-PAK™ User Guide – Rev. C
2. Loosen the screw on the bottom of the battery.
3. Insert the slots at the top of the battery into the 2
hooks at the top of the battery cradle.
4. Lower the bottom of the battery into the bracket at
the bottom of the battery cradle.
5. Carefully press the bottom of the battery to
connect the female and male power connectors.
The battery snaps into place.
6. Tighten the screw on the bottom of the battery.
7. Verify battery function. Turn on the switch on the
top of the battery. The red LED illuminates. At
power-on, the LCD display shows the setup
screen.
„ Battery
Removal
1. Turn off the switch at the top of the battery if it is
on. The red LED turns off. Unplug the battery
charger if it is connected.
2. Loosen the screw on the bottom of the battery.
3. Grasp the battery at the bottom.
4. Carefully pull the battery up from the bottom until
it is free from the bottom bracket of the cradle and
the 4-pin power connector on the back of the
radio.
5. Slowly continue to pull the battery up from the
bottom. The battery will disengage from the 2
hooks at the top of the cradle.
6. After the battery is removed, re-tighten the screw
on the bottom of the battery to avoid its accidental
loss.
4-53