NavCom SF-2040 Rev.C User Manual
Page 135
LAND-PAK™ User Guide – Rev. C
5-131
button to add the current point in the Stake Points
window to the list. Tap the Pick from List button to
view the Stakeout Point List window and stake
any of the points on the list.
• Source: After selecting a point or points in the
Stake Points window, SurvCE displays the source
of the point(s), either as Current Job or Control
File.
The display of the source is important
because the current job file and a control
file may contain the same point ID.
• Point by Direction: Check this option to st e a
poi
d
ak
nt defined by a direction and distance, an
slope if applicable, from the current point
coordinate. This enables points to be staked
without calculating point numbers or point IDs for
the target point. Enter t e be
h
aring/azimuth,
horizontal distance and also slope, if applicable.
If the distance entry is not known but
must be computed, access the
calculator. Tap in the H. Distance field.
Press the 2
nd
button on the Explorer
600+ keypad. Press the 0/? key. The
calculator opens.