NavCom SF-2040 Rev.C - Manual (Page 171)

LAND-PAK™ User Guide – Rev. C
C-167
C ................................ TruBlu Configuration
This appendix provides steps to install and configure
the supplied TruBlu™ module. TruBlu provides
wireless control and logging of up to 10Hz position
records in the Explorer 600+ controller.
COM1 of the SF-2040 GPS sensor, both base and
rover, is the LAND-PAK Control Port. Prior to the
installation of TruBlu, the supplied serial cable (P/N
94-310090-3003) is used to connect the Explorer
600+ controller to COM1 to set its baud at 19200.
This is important because TruBlu only works at 19200
u
low:
supplied
or.
2. Power up the SF-2040 GPS sensor: on the
indicator panel of the sensor, depress the on/off
(I/O) switch for more than 3 seconds.
‡
All GPS sensor LEDs illuminate for a
period of 3-5 seconds during power-
up. Refer to the supplied SF-2040
GPS Product User Guide for details
on GPS sensor LED indications.
Press the Explorer 600+ power button
ba d.
Refer to
1. Connect the LEMO 7-Pin end of the
Figure 51 for the cable connections be
serial cable to COM1 of the SF-2040 GPS sens
Connect the female 9-pin serial connector end to
the Explorer 600+ controller.
3. to
boot up the Windows CE desktop. The icon for
con on the desktop. The
Carls
4. Double tap the SurvCE i
on SurvCE is on the desktop.
SurvCE job selection box opens in front of the
main menu.