Figure 68: configure satel radio window – NavCom SF-2040 Rev.C User Manual
Page 108
LAND-PAK™ User Guide – Rev. C
5-104
Figure 68: Configure Satel Radio Windo
o Figure 68 for the settings below:
the power and channel (frequen
w
Refer t
9. Set
cy) options for
the
•
•
e
ND-PAK 869
configuration): The RF power output options
are from 10 to 500 mW.
10. Set the Squelch to Low (recommended).
11. Tap
base radio modem as needed.
3ASd Epic radio modem (the LAND-PAK LM
configuration): The RF power output options
are 1, 2, 5, or 10 watts. The 10 watt setting
provides the maximum range and causes the
maximum discharge on the battery. Select a
lower setting for surveys over small areas.
3ASd 869 radio modem (th LA
to accept the settings. The GPS Base
submenu returns (see Figure 67).
12. Tap
to accept all the settings made on the
tabs of the GPS Base submenu. The Base
Configuration window opens (see Figure 69).
13. Continue to the next section to assign a geodetic
position to the base station for computing elative
r
GPS positions between the base and rover.
- SF-3050 Logging Data to Internal Memory SurvCE (4 pages)
- SF-3040 Logging Data to Internal Memory or SD Card (6 pages)
- SF-3050 Logging Data to USB Using SurvCE (4 pages)
- StarFire over IP (5 pages)
- SF-3050 Quick Start (4 pages)
- SF-3050 A Computationally Efficient Ambiguity Resolution (7 pages)
- StarFire (5 pages)
- StarFire to SW v3.0.12.0 (3 pages)
- SF-3050 Rev.I (196 pages)
- StarUtil-3000 Rev.G (177 pages)
- Sapphire Rev.L (450 pages)
- StarUtil-3000 Rev.A (119 pages)
- SF-3050 Rev.A (169 pages)
- SF-3050 Rev.B (201 pages)
- SF-3050 Rev.D (235 pages)
- Rinex Utility Rev.D (17 pages)
- SF-3040 Quick Start (4 pages)
- SF-3040 Rev.F (217 pages)
- SurveCE Integration Rev.A (150 pages)
- Install Utility Rev.C (26 pages)
- LAND-PAK Quick Start Rev.B (7 pages)
- LAND-PAK Rev.E (156 pages)
- StarUtil Rev.C (58 pages)
- LAND-PAK Rev.N (194 pages)
- StarUtil Rev.B (8 pages)
- StarUtil Rev.F (134 pages)
- SF-2040 Rev.E (63 pages)
- RT-3010 Rev.E (61 pages)
- StarFire Satellite Change Rev.G (24 pages)
- StarFire Satellite Change Rev.I (23 pages)
- TS Collecting Receiver (2 pages)
- TS Factory Default (2 pages)
- LAND-PAK Rev.F (159 pages)
- SF-2040 Rev.F (93 pages)
- RT-3020 Rev.F (93 pages)
- SF-2110 Quick Start Rev.A (2 pages)
- StarPac Rev.A (15 pages)
- StarControl Rev.C (56 pages)
- SF-2050 Rev.F (99 pages)
- TruBlu Rev.A (2 pages)
- VueStar Rev.B (13 pages)
- SF-2110 Rev.B (99 pages)
- StarUtil-2110 Rev.A (85 pages)
- RT-3010 Rev.F (89 pages)