Rminator…… 75, Y - bus terminator – Measurement Computing Digital488/80A User Manual
Page 81
Y - Bus Terminator
SYNTAX
Yn
Define mode
n
of IEEE 488 bus terminator, where
n = 0
,
1
,
2
, or
3
.
Y0
(Default) Define carriage-return line-feed (
CR LF
).
Y1
Define line-feed carriage-return (
LF CR
).
Y2
Define carriage return (
CR
) only.
Y3
Define line feed (
LF
) only.
Y?
Returns current bus terminator mode
n
.
Note:
To save a bus terminator as the new default setting, use the Save Configuration (
S
)
command
S0
.
DESCRIPTION
At power-up, the IEEE 488 bus terminator defaults to the Bus Terminator (
Y
) setting saved in configuration
0
(the
power-up configuration). It may also be programmed for any combination of carriage return (
CR
) and line feed (
LF
).
Mode
Y0
is the most commonly-accepted terminator (
CR LF
). Mode
Y1
reverses the sequence (
LF CR
). Mode
Y2
sends carriage return (
CR
) only, while mode
Y3
sends line feed (
LF
) only. To save a bus terminator as the new
default setting, use the Save Configuration (
S
) command
S0
.
EXAMPLE
PRINT#1,"OUTPUT08;Y3X"
Line 1: Select the line feed terminator.
Digital488/80A User’s Manual
967695
Digital488/80A Commands 75