Kanguru 4HD SATA - Manual (Page 48)

48
3.4.14 Resize Part.
The Resize Partition function allows you to define partitions on the Master hard drive that will be
Resize Copied to the Target drives. The available modes are: All, End, ID0, ID1, ID2... ID99. “All”
will resize all partitions. “End” will resize only the last partition. ID0 - ID99 will resize one specific
partition, (ID0 resizes the first partition, ID1 resizes the second partition, ID2 resizes the third partition,
etc...).
For example, you have an 80GB Master drive with two 40GB partiions and you are Resize Copying
it to a 160GB Target drive. You can configure the Resize Partition function so that after copying is
completed, the 160GB Target drive contains two partitions, where the first partition is 40GB and the
second partition was resized to 120GB.
DIAGNOSTIC
TOOL
CONFIGURATION ->
<- Back UP/DN Sel ->
HPA CHK: ENABLE
Trans BLK: AUTO
Resize Part.: ALL ->
<- Back UP/DN Sel ->
Resize Part.: ALL ->
<- Back UP:Add DN:Dec
1. From the Setup Menu, press the UP or DOWN buttons to
navigate to CONFIGURATION mode. Press the RIGHT
button to enter CONFIGURATION mode.
2. From the CONFIGURATION Function Menu, press the UP
or DOWN buttons to navigate to the RESIZE PART function.
Press the RIGHT button to enter the Resize Partition Setup
Menu.
3. From the Resize Partition Setup Menu, press the UP or
DOWN buttons to configure the Resize Partition mode. Press
the LEFT button to confirm the Resize Partition mode.
Resize Part