Kanguru 4HD SATA - Manual (Page 39)

39
3.4.6 Cap. Chk
The Capacity Check function allows the KanguruClone to check the capacity between the Master and
Target hard drives to determine whether they are the same.
You can enable or disable the Capacity Check function. Capacity Check is disabled by default.
• Enable - When the user executes a Disk Copy or a Brief Copy, the KanguruClone will check
the capacity between the Master and Target hard drives to determine whether they are the same
or not. If the capacity is different between the Master and Target hard drives, the KanguruClone
will cancel the cloning process. The LCD screen will display “CAP” in the upper right corner
of the Main Menu if Capacity Check is enabled.
• Disable - When the user executes a Disk Copy of a Brief Copy, the KanguruClone will not
check the capacity between the Master and Target hard drives and the cloning process will begin
normally.
DIAGNOSTIC
TOOL
CONFIGURATION ->
<- Back UP/DN Sel ->
POWERON WAIT: 12s
POWEROFF WAIT: 0s
CAP. CHK: DISABLE ->
<- Back UP/DN Sel ->
CAP. CHK: ENABLE
<- Back UP/DN: Change
1. From the Setup Menu, press the UP or DOWN buttons to
navigate to CONFIGURATION mode. Press the RIGHT
button to enter CONFIGURATION mode.
2. From the CONFIGURATION Function Menu, press the UP
or DOWN buttons to navigate to the CAP. CHK function.
Press the RIGHT button to enter the CAP. CHK Setup
Menu.
3. From the CAP. CHK Setup Menu, press the UP or DOWN
buttons to change whether Capacity Check is enabled or
disabled. Press the RIGHT button to confirm the Capacity
Check status.
Cap. Chk